Author: iDONULL
-
3D Print on a Clean Plate and How to Remove Stubborn Residue
Written by
on
Applying glue sticks to the 3d print build plate is an effective way to secure the print during the whole printing process. And it is not causing too much of…
-
Remove The Filament Blob, Save your 3D Printer Nozzle
Written by
on
In my last post, I talked about the root cause of the filament blob, which not only ruined my print jobs, but also paralyzed my 3d printer. I was able…
-
3D Print Model of Pokémon Card Protection Cover
Written by
on
Download and 3d prints these protection covers to guard your precise Pokémon card, especially helpful during shipping in standard mail envelopes. The printed cover design is low profile, less than…
-
3D print model of porous container and a funnel lid
Written by
on
The container and funnel set was designed for the easy filling and application of the desiccant beads. Please use the links below to download the STL models for your own…
-
Save Your 3D Printer From The Filament Blob of Death
Written by
on
Have you ever seen your 3D printer in a “catastrophic failure” like this? The filament did not stick to the build bed but accumulated into a giant “beehive” blob underneath…
-
Install Shut-off Valve on Pool Filter Waste Drain for Easier Maintenance
Written by
on
My Pentair pool filter had a plug at the bottom of the tank, which was very hard to reach. Every time during the filter cleanup, I had to crawl underneath…
-
Build My Dream Home Library (5) One Man Middle and Top Cabinets Installation
Written by
on
During my last post when I built and installed the lower cabinets for the library bookshelf, I started to have a sense of the weight of the 3/4″ plywood cabinets:…
-
Build My Dream Home Library (4) The Lower Cabinet Boxes and Face Panels
Written by
on
Since the cabinets are designed to be used as library bookshelves, the depth of them should be shallower than the standard kitchen cabinets, which are usually 24″ deep for the…
-
Build My Dream Home Library (3) Wood joint method
Written by
on
I went through lumber choice in my last post. Now it’s time to talk about how I was going to put all the pieces together to construct the cabinets. Again,…
-
Using a Stencil for DIY PCB Assembly with a Homemade Reflow Oven
Written by
on
In my last post, I talked about manually assembling a small-scale PCB project at home with my reflow oven. I’m happy to report that a lot of the boards are…